Once per trade doesnt work pls help
-
@l-andorrà WIth the blocks I use forms the same result:
THis is how it should be.
as you can see it didnt stop and reenter. its just want through until it hit stop lost
the thick line have a value of 5 and the thin line have a value of 10
-
@l-andorrà how would you do?
-
Sure. Could you please share your latest version?
-
@l-andorrà its the same. I still cant figure it out how I can trade 1 at the time and how ir close when the RSI reach a new condition
-
Try this for sells only. I recommend you to duplicate it for buys.
-
@l-andorrà why is pending order sell replace with sell now? The strategy is base on pending order
-
Because you said it was the same and the last version you shared (see previous page in this thread) does not include any pending order.
-
@l-andorrà my bad. I just change the new one with pending with closing like the picture before.
Futher more about the project there are a few question. There are two ID. 1 and 2. why is that. if you do that means trade two times. right? -
@l-andorrà I use pendding order. Should i put delete pending order on the red or yellow. right next to the close trade?
-
@setsuna said in Once per trade doesnt work pls help:
@l-andorrà my bad. I just change the new one with pending with closing like the picture before.
Futher more about the project there are a few question. There are two ID. 1 and 2. why is that. if you do that means trade two times. right?I usually use two diferent condition blocks when defining crossings. I guess your crossing didin't work for this reason. If you do it as I suggested, you will be sure there was a crossing on candle ID 1. And no, there will not be two trades, just one.
-
@setsuna said in Once per trade doesnt work pls help:
@l-andorrà I use pendding order. Should i put delete pending order on the red or yellow. right next to the close trade?
If you don't need the 'Sell now' block you can simply substitute it for the pending order one. That will not change the way the EA works.
-
@l-andorrà I tried everything. But its still put a order when there is already another order. I guess its to hard to write a EA that can trade 1 at the time
Well thank you for the trouble, I give up. Im out
-
@setsuna you can use fxdreema builder on phone only if you have a vps subscription , there are lots of cheap ones out there under 10$ i use to do this when i was traveling and dont have my laptop with me
-
Ok. Could you please share again your latest version?
-
@l-andorrà i Have figure it out. but thanks anyway
-
@l-andorrà hello the problem havent solve
I like to trade one trade at the time.
this the project: https://fxdreema.com/shared/yGsNtYDnb
I think I miss something
-
According to your shared link, one pending buy and one pending sell should be launched at the same time. I no case two buys or two sells as apparently is suggested by your screenshots. Are you sure this is your whole project?
-
@l-andorrà well I solve the problem of one time trade at the time. but a new problem raise.
this is my new problem. When I back test. Its only go 1 month. https://fxdreema.com/shared/3DL4i7Fub -
As fas as I can tell, the EA is correct. There must be a problem with your tick data maybe.
-
@l-andorrà Is that a fxdreema error of or my broker error? If its a fxdreema problem I hope mr Dreema could fix it
