Trailing to Block

[zedeai2]

Hello all,

I want to do trailing to the selected block.
To connect them, I do type 101 inside of the trailing block (section filter by group), because this number 101 is the target block area number (101)

Is this structure correct?

Always Thank you for your all support!

[TipsyWisdom]

block # 1,929,821,663?? lol! You are a very persistent person.

Be careful that blocks are in the correct number order in regards to logic!

[TipsyWisdom]

Dont forget to use "If trade" block before that trailing stop block.

[zedeai2]

@jsauter86 Hello, I don't know why this number is too much:)

[zedeai2]

@jsauter86 if I don't use "if trade", so what will be happening?

[l'andorrà]

@zedeai2 Individual blocks do not work in fxDreema. This is why another block is required for the trailing stop block to be fully operational.

[TipsyWisdom]

the logic of the trailing must be, "If trade," then "Trail Stop." But if you don't preface with a block prior like "If Trade," it doesn't know to look for a trade to trail. I have not been able to make it work with other similar blocks, only the "If Trade," can come before the trail stop and break even block...but I'm not very good at the specifics of this software. I'm sure other things can make it work....I just stick to what I know works usually unless I have to find another way.

[zedeai2]

@jsauter86 Hello,

I read on this article about trailing https://fxdreema.com/howto#Trailing

Is that mean there is some options to do trailing : if trade, no trade is running, Pass, hours filter?

Thank you!

[zedeai2]

@l-andorrà I see.. Thank you!