Why am I getting loss trades because trades are not closing at 2 MAs crossing?
-
@veetee sorry if i disturb, have you tried the project that i linked above?
-
@veetee said in Why am I getting loss trades because trades are not closing at 2 MAs crossing?:
@tipsywisdom hi, thanks for the tip. it does not work with no group numbers. I use it to separate the closing of the buys and sells. How do I set everything to automatic?
buys and sells should only be handled as buys and sell, not with group numbers...it further complicates things beyond expectation. Unless you absolutely need to have group numbers, dont. Buy and sell is more than enough. Now when you start enter several buy positions for different reasons that need to be handled in a variety of take profit scenarios, thats why you would need group numbers.
outside of that, your no position blocks have the incorrect logic.
How do you expect to close the profitable positions after that condition is met if the no position block is only filtering for buys to pass through? -
@tipsywisdom yes thanks for this. I obviously didnt see what was inside. I usually use buys and sells on the no position for these and group2 for sells from the second tree. I will have another look at this to see whether there are any missed crossing points.
-
@tipsywisdom I have checked this construction again and it is still missing. It is so annoying that it is missing many of the crossing points. https://fxdreema.com/shared/MaIDDudP In addition the 2 tree construction where the trade is closed on the same tree the fx dreema example buy-sell-buy is also missing crossing points. i did check inside the buy sell blocks and they are set to run for one day or one hour but even when corrected it still missed the crossing points.
-
@ambrogio Thanks for the advice. The buy sell blocks are set to stop after one hour, or one day and this is extremely annoying, but removing this did not make any difference. i thought that these settings would not affect my EA because i always set to no expiry
