Hi again fxDreema,

At least, you got what my idea it is.

In order to make you grasp my idea fully, let me explain more.

When the condition in my EA met, buy/sell trade will initiate.

Let say the idea only 4 symbols/pairs are allow to trade simultaneously.

For this situation, 4 symbols/pairs already initiate a trade. Doesn't matter how many trade(layer/volume added) in these pairs, as long as only 4 of these symbols/pairs were involved.

If the condition also met in the 5th symbol/pair, buy/sell trade will not initiate until one or more current symbols/pairs traded have reach Take Profit/closed trade. This is to maintain 4 symbols/pairs limitation.

This idea is very useful if account balance was limited.

Let say, my account balance can only withstand 4 symbols traded at one time (unrealized loss/floating amount).

I just imposed the condition to trade only 4 symbols at one time.

So, with this idea we can limit any numbers of symbols to be traded at one time depending on account balance.

This is due to known fact , we don't know which symbols will initiate trade first. As the EA will be attach to maybe 28 symbols/pairs chart or more.

If you can implement this idea, I'm sure our EA will be more flexible with any account balance.

Thanks.

Hi fxdreema,

Can this condition block limit pair traded at one time?

https://fxdreema.com/shared/2ckslDrgd

A bit difficult to test the idea due to backtest only allow one pair at one time.

Thanks.

@fxDreema I remove it by reloading my template.

Reloading the EA and setting via template.

Nothing to worry right?

It run without any problem.

Thanks.

@fxDreema

Hi,

Can you take a look at this warning.

This warning came up after the update. Should I just ignore it?

Is this normal log when I remove the expert advisor?

Just let me know.

Thanks.

Hi,

A few hours ago, I have no problem generating the same EA.

Now, this error come up.

Kindly look into this matter.

Thanks.

Hi Again,

I think I can figure it out right now.

In a different way in order to make my setup works.

Thanks.

Hi Again fxdreema.

Just need to verify something, as example shown below

https://fxdreema.com/shared/OtlhzDrme

Two kinds of setup was created in the example. The reason I put it in separated area was to avoid interfering each other setup.

Of course, the current condition of the example would never interfering each other setup. I think you got my point.

In more complicated setup, I'm worried both buy and sell setup which have similar condition will interfering each other block flow.

My question is, if i put buy and sell setup in separated area, does the block flow just run within its area only (start to finish)?

Thanks.

Hi fxdreema,

Can you kindly suggest a condition or an idea as below:

no trade on candle id 2... excluded candle id 1 (if trade on candle 1)

And the block flow will pass.

Block "no trade nearby" only can be set based on price.

Thanks.

Thanks a lot admin.