






Latest posts made by h.a
-
RE: گروه روبومستر سلیمانی خواهposted in Questions & Answers
چطور میتونیم FVG مشخص کنیم
FVG : کلمه FVG کوتاه شدهی عبارت Fair Value Gap و به معنای «شکاف ارزش منصفانه» است. FVG بین معاملهگران پرایس اکشن و ICT بسیار محبوب است و در غالب اوقات نشاندهنده ناکارآمدی (Inefficiencies) و عدم تعادل (Imbalance) در بازارهای مالی است.به یک طرف فقط سفرس داشته باشیم

-
RE: گروه روبومستر سلیمانی خواهposted in Questions & Answers
@somi87 
هر مودی هم که خواستی تغییر بده مثلا -
RE: گروه روبومستر سلیمانی خواهposted in Questions & Answers
@areffarokhzade
و چطور تعریف کنم بدنه کندل 1 دو برابر بدنه کندل دو باشه
خیلی ممنون از راهنماییتون -
RE: گروه روبومستر سلیمانی خواهposted in Questions & Answers
چطوری میشه تعریف کرد که کلوز کندل 1 حد اقل 20پیپ از کلوز کندل 50 کوچکتر باشه
-
RE: گروه روبومستر سلیمانی خواهposted in Questions & Answers
@abbasnor said in گروه روبومستر سلیمانی خواه:
@abbasnor said in گروه روبومستر سلیمانی خواه:
@areffarokhzade اول یه بلاک pass بزار رو modify varibles تا کار کنه
-
RE: گروه روبومستر سلیمانی خواهposted in Questions & Answers
چطوری میشه تعریف کرد که کلوز کندل 1 حد اقل 20پیپ از کلوز کندل 50 کوچکتر باشه
-
RE: Break the trend line and determine the floor higher than the previous oneposted in Questions & Answers
@h-a said in Break the trend line and determine the floor higher than the previous one:
1- We specify low 1, low 2
2- low 1,2 < ma 50
3- We specify up 1 and up 2
4- We draw a line from up 1 to up 2 and to the lowest price lo 1
5- The interval between lo2 and up 1, the candle that is green and has the largest volume and is below up 2, we determine the buying area.
5-1- If there was another candle in the specified area that was close to the maximum volume, we will buy it in the same area.
6- We can place a purchase order in 4 parts of volume 1 or volume 2 candles
6-1- If two candles were large, then we have 8 prices (H.L.O.C), we can use the martingale method
7-SL We place a few pips lower than the lowest available price at the lo 1 floor
8-TP should be a bit lighter than up 1 or variable
If we don't want to use the martingale method
We go to a lower time frame (H 1)==>(m 15)
Then we repeat step 4, which was to draw a diagonal line
And we do step 3 and 4 again and set minute up2 point as entry point and set SL, TP as before.
