Hi All

I have an Indicator that I was trying to work out what the Buffers did. I built a simple ea using a Pass & a Trace Block so the EA would put a line on the chart when that buffer was activated.

I compiled the indicator in Metaeditor & got no errors. I then compiled the EA & got seven errors all saying the same thing " 'iCustom' Wrong Parameters Count" . Line & Column are given where the error in the Code occurs and I can find the line but not the column. The EA symbol in the Navigator window also has a small diamond symbol in the corner which is normally gold whereas mine is gray. Is this a symptom of the problem?

I have attached a picture showing the EA symbol in the Navigator window, the Indicator and the EA in question.

Any help would be greatly appreciated.

Thanks

......
BUY SELL.mq4
Navigator_001.png
BUY SELL BUY.mq4

Fx Dreema

Thank you for your help.

My issue was not with where the Indicator placed the arrows but where my EA was placing the diamonds. i.e one bar after the indicator arrow.

I have found the fault. It has to do with the Draw Arrow placement, I had time set at Candle ID 0 and Price at ID 1. Both should have been the same to get the position of the diamond where I wanted it.

Thank you for such a great product

Hi

I have an Indicator that I am trying to get the buffers correct on in the condition blocks before I add other blocks. I am checking my setup by adding Draw arrow blocks & then running what I have through the EA Tester. Here is what I get... EA_Test_results.png [attachment=1:vrm2uqhd]https://fxdreema.com/shared/yndLq7dzc

......
EA_Test_results.png
Heiken Ashi Arrows_mtf nmc.mq4

fxDreema

Could you please explain your comment how that "Indicator appear", acts a little bit differently than "Condition"?

Thanks
Justin