Topics created by shyamvinjamuri

Check in Price levels in Condition, there is what you search for. Otherwise, the fastest method is to use bigger timeframe, if possible.

Is it possible that Ask>=High[1] and Bid<=Low[1]... maybe, if candle 1 is smaller than spread. I was not able to see sells on my backtester.
When both conditions are so different that cannot happen in one time, connect them in parallel. In your case block 6 should be connected after block 5, not after Buy now. If both conditions can happen in the same time, using "OR" block is good to prevent blocks after conditions to be executed more than once in one tick.

The candle ID is very important and useful. I use it to see when moving averages crossover. So for bull crossover FastEMA (ID 2) < SlowEMA (ID 2) and then FastEMA (ID 1) > SlowEMA (ID 1) and also for intensity of bullish trend FastEMA (ID 2) adjust by +pips < FastEMA (ID 1) etc

There were no error messages. I will try again tonight.

Thank you

Thank you for all the help. I think I am getting a hang of it.

http://fxdreema.com/shared/99a4SgY3c

Block "test" is only to draw line of the lowest values for you to see it, it is not to be used as indicator.
This project will work on web version only, because now I made some changes in the way lowest/highest values are calculated. Also I set it up that when the "End" hour is still in the future (so we are between 0:00 and 5:00), the block ("Condition")will not pass at all.