Once per bar after signal

[cfabian]

Hello,
If need a crossover to validate my entry signals (fresh crossover, meaning in candle -1, recently closed), and then want to activate the once per bar, how should this be configured and connected? My guess is that if the EA has "once per bar" connected to the "crossover condition", it may cause errors or wont work as after say 2,3,4 candles, all of them will be apart from the crossing candle, thus that crossing is not candle -1 anymore.

I thought of using a larger "cross width" value, but then it wont respect the need of having a fresh crossover, and could enter in late trades.

Thanks for your help

[fxDreema]

Don't change cross width if you don't understand it.

This is the example about Once per bar and how it can be connected with Condition, it also contains description - https://fxdreema.com/demo/mt4-once-per-bar

[cfabian]

Thank you... but still not clear to me...

For example, how to set up that only after a fresh cross happens (closed bars, meaning cross in candle -1), then it starts to place trades once per candle? Not in the middle of the run, but when it starts a new "crossing cycle"?

Thanks

__Don't change cross width if you don't understand it.

This is the example about Once per bar and how it can be connected with Condition, it also contains description - https://fxdreema.com/demo/mt4-once-per-bar[/quote:143wfbmy]

[fxDreema]

I don't understand this "crossing cycle". If you want to do something on each candle after crossover until the next opposite crossover comes, you know, you don't even care about crossovers. If MAx crosses MAy above, then until the next opposite crossover you can be sure that MAx is > MAy. So you can just use > or <

[cfabian]

By cycle I mean from start to end of the crossover, but my only valid signal is the crossover (closed candle). If I use > or < it will be a permanent signal during the whole cycle, while I only need fresh signals right after crossing. Once per bar for 5 bars right after crossing. Not in the middle of the cycle.

Thanks

__I don't understand this "crossing cycle". If you want to do something on each candle after crossover until the next opposite crossover comes, you know, you don't even care about crossovers. If MAx crosses MAy above, then until the next opposite crossover you can be sure that MAx is > MAy. So you can just use > or <[/quote:oit0s6ug]

[fxDreema]

https://fxdreema.com/shared/hyvOISJ8e ?