@ambrogio Thanks a lot
My problem was completely solved with your help

Regards

@Flier66 salam refigh
tools > Option tik allow dll ro bezan ok mishe

@l-andorrà By zigzag indicator, it means low(by ID)

Hi

When L1 is crossed below, I want it to draw an arrow on the crossed candle and not do it again until the value of L2 changes.
https://fxdreema.com/shared/hB4gTf0se
Now it is drawing an arrow on all the candles that have crossed L1
as picture show

@jstap here you are

https://fxdreema.com/shared/yHZu5gvod

Hello everyone

I want to make this condition:
The close of 26 candles before being under the Chinkou Span line but it didn't work, I checked it and I understand that the Chinkou Span line does not work at all, I tested it by a simple condition that the Chinkou Span cross above Tenkan-sen but it still didn't work.

Why the Chinkou Span line does not work?

I read some of the question and answer and I almost understand that it is because of candle ID 26, but I didn't get it!

@l-andorrà This is how to execute a trade sequence:
The Strategy entered a Buy trade, It is closed at a loss.
The strategy may give another entry signal many hours later, but I want to reverse the position that closes at stop loss (open at the stop loss point) only one time, after the reverse operation, the robot should stay till the strategy give its next signal

@l-andorrà The purpose of this work is to test because as you said, this idea has no special logic
The entry points of the strategy are in such a way that, in most cases, when the loss limit is reached, if the choice is reversed, the loss of the previous trade is compensated by entering the trade in the opposite direction.

I just want to test if this is useful or if it increases the number of losses.

@Flier66 salam refigh
tools > Option tik allow dll ro bezan ok mishe

@jstap Thanks a lot, it solved with your help

@jstap Thank you, dear
I need to make two conditions

1. The histogram should change from red to green (as you say, the main line cross above zero becomes the first condition)
2. The main line is below zero, according to the picture(how doing the second condition)

Looks like I need a Mac with two lines and the MACD in trading view is different with Metatrader and I can not do this condition with standard MACD.
Did I understand correctly?

Hello
I want to determine when the MACD histogram changes from red to green and the MACD mainline is below zero

Like the picture, the blue line, which is the main line, is below zero and the histogram has changed from red to green
I did this project but the arrow shows unrelated candles
My problem is the MACD indicator in Fxdreema only has 2 modes:
Mainline and Signal line
But in the trading view, there is Histogram, Mainline, and Signal line
https://fxdreema.com/shared/aBwlmiMrd