Posts made by Miroslaw

@l-andorrà
Yes, I tried. I created something like this, but it doesn't work the way I want.
https://fxdreema.com/shared/mTl4Ee8qd

Thank you
I will try it

Hello. I am a beginner and I have a request for help. How am I going to start building an EA with the following parameters.
EA places orders awaiting the open day candle (TF 15 min) at the specified time.
BUY - if the price is below X pip open day candle.
SELL - if the price is above X pip open day candle.
Take Profit X pip on the order
Stop loss X pip.
Thank you for any help.

https://fxdreema.com/shared/EpimUhbxe

Hello
Can you see it?

Hello.
Thank you for your help and patience.
I did tests on the tester in mt4 and it turned out that the transactions were only made on BUY, while when I tested on the demo account on Wednesday, EA opened several positions for me between 9:00 and 10:00. I changed in the bull candle and bear candle block in the section, signal type, from continuous to once per bar. I tested it on mt4 and it was better. Now I would like you to tell me how to make the candle preceding the opening candle meet the condition that the closing of the candle must be within 25% of the range
I wish you a nice weekend.

https://fxdreema.com/shared/CfJJ8Aruc

Hello again, I hope you had a nice weekend. I am sending you a link and please check if that's what it is

It was like that before but then I followed your suggestions and changed it, I only have blocks 1,2,3,8,9,5 I sent you this. Maybe I did something wrong? and by the way, a hint on how to do screenings will send you what I have.
Have a nice weekend.

https://fxdreema.com/shared/y2dZLkcGd

@miroslaw said in I have no idea how to start.:

But I don't have these blocks, I only have 1,2,3,8,9,5

@miroslaw said in I have no idea how to start.:

I did what you suggested, but apparently I'm a weak student because I don't know what to change, can you tell me? Please.

https://fxdreema.com/shared/z2vSbDMNd

Is it better now?

Could you tell me how to add to this robot that the candle preceding the order must have a body not less than 76% at the closing?

@miroslaw said in I have no idea how to start.:

Can you write me what I ignored your advice? Now I tested these settings from 1/1/20 to 17/09 and it was quite a good result with 10000 the robot did 12375 I changed only an hour. I'm only concerned that after changing the hour, it closes my positions not after one hour, but after two. What should I do if this difference should be closed after an hour.
Best regards.

https://fxdreema.com/shared/z2vSbDMNd

Thanks for your the congratulations. I corrected what you showed me, does that make any sense now? I haven't tested it yet, maybe something came out of it.