Thank you, Andorra.
Yes, I've tested the criteria in manual trading, and it works. However, in this expert, it doesn't. I'm a bit puzzled about where the issue might be.
Latest posts made by Mrfgn
-
RE: Multitimeframe Issue with Fxdreema Expert Creationposted in Questions & Answers
-
RE: Multitimeframe Issue with Fxdreema Expert Creationposted in Questions & Answers
Hello Buddy
Thanks for your assistance, and I apologize for my delayed response due to health reasons. I'd like to share a link with you. In my setup, I've labeled my trendlines as 'support_line' and 'resistance_line' in MetaTrader. For example, Placing these trendlines on a 15-minute chart triggers orders when specific criteria align simultaneously at the same time frame.
https://fxdreema.com/shared/1aAuoddAcHowever, my previous message addresses the challenge I'm facing: linking the 15-minute timeframe, where I've positioned the trendlines, with the 1-minute timeframe where I aim for the trigger criteria to activate and execute orders.
https://fxdreema.com/shared/MlCXO3oye -
RE: Multitimeframe Issue with Fxdreema Expert Creationposted in Questions & Answers
https://fxdreema.com/shared/MlCXO3oye
Hi Buddy
I'm working on developing a semi-automatic trading expert. The idea is that when I draw a trendline on a 15-minute chart, it should trigger a particular state (let's call it "State 2"). I've had experience with semi-automatic experts in the past where placing a trendline on a chart led to a position being entered on that same timeframe as the trendline. However, in this project, I want to do something slightly different. Specifically, when I draw the trendline on a 15-minute chart, I want the trigger and the actual trade entry to take place on a 1-minute chart.I hope this clarifies the concept I'm working on. If you have any insights or suggestions, I'd appreciate your input.
-
Multitimeframe Issue with Fxdreema Expert Creationposted in Questions & Answers
I'm currently working with Fxdreema to create an expert, but I've encountered an issue. My goal is to create a supply and demand zone in a 15-minute time frame, which then triggers a state change to "state 2." In "state 2," I have specific conditions set for a one-minute time frame.
I've attempted to connect these states using "set" and "check" flags, but unfortunately, it's not working as expected. I would greatly appreciate your assistance in resolving this issue. Your guidance would be immensely valuable.