Posts made by shack11

@l-andorrà
Still the same:

@l-andorrà
https://fxdreema.com/shared/NrFTZJExd

Cheers!

That's what I'm getting if I add your tree to the same tab as my tree. Yours has higher ID numbers ...

Should I add another block to "introduce" the boolean "active again" ?

@l-andorrà
Im not sure I got this, Is the "small tree" you did for me suppose to be connected to the my whole tree ? or it should be separated and I need to create another block to add to the top of my tree ? Thanks

@len-1 Thanks.
Yeah I want it to be cyclical then, after every trade that the bot initializes...

Is there a way to do it ? cheers.

@len-1 said in Time limit from last trade:

cyclical

What do you mean by cyclical ?

Hi, I'm looking for a way to prevent the EA from making another trade if there was one before.
Now for an example: My EA is working on the H1 time frame and checking the conditions every round hour. Im trying to avoid opening a position after position.
lets say there was one trade at 09:00 and closed at 09:40. now I want the EA to NOT open a new trade at 10:00.
I guess I'm looking for a "cooling period" of at least an hour between trades...

Thanks a lot !

I'll try that.

Thank you very much!

Thanks for your replay.

Unfortunately, that is not helping with my issue.

What I need is a block that checks if there is already an open trade with one of the currencies, here is another example:

I have an open position on AUDUSD and now there is a signal to enter another trade on EURAUD.
It means that AUD is already on my open positions. I need the EA to recognise that condition so it could take different size on the next trade (with AUD).

Hope it makes sense...

Thanks

Hi
I was wondering if there's a way that before entering a trade, the EA will check if there's an open position already with the same currency ? for example: Let's say that I'm already in a long position on EURUSD and then there's a signal to enter a trade on EURAUD. In that case, I want the EA to direct to a different block.

Hope I was clear enough.

Thanks a lot.

@l-andorrà said in Indicator cross width:

The answer is here:

https://fxdreema.com/instructions/builder/crossover

Thank you !

Hi
I'm trying to figure out if the number in "cross width" refers to the candle that actually cross ?
In the screenshot, Is "1" means that this block pass when the previous candle crossed 0 ?
I'm trying to set it to pass when candle 2 (previous to previous) crossed but unfortunately if I change "cross width" to 2 its not whats happening.

Thanks a lot!