Posts made by Flip

Hello,

I am using the Draw Edit Field block. I want to know if there is an easy way to exclude an numeric entry that includes a comma. If a "." is entered for a value it should be allowed, but when a "," is used it should give a message like "invalid" or so. Is there an easy way to do this as I am not a programmer?

Thanks

@josecortesllobat Thanks! I was just looking into reducing the blocks. Although I did not get the right results with the candle body size (probably because it is in pips), I was able to reduce the project with one block. I now have this:

@isp00rt Sure, here it is:

I finally solved the issue. My calculation was not complete I realized. I needed to add another formula block. All good now;)

@jimmy-chee

Thanks I will try to see what happens

I don't understand what you mean.

I have used 2 different variables for previous candle open (candle1OpenM5) and close (candle1CloseM5). Than I used a 3rd variable, which is the difference between (candle1OpenM5) and (candle1CloseM5) divided by 2 and stored in variable (variableprice_M5_short).

I have been trying the following for hours but without success.

I want to store the price level of the previous candle (ID:1) body /2. In other words the price level of 50% previous candle body.

I tried formula block, but it doesn't seem to work yet.

Can you please help me out?

Thanks! I will have a look at this.

I have seen the Time filter blocks but I can't figger out how to do the following.

Every M5 candle needs to be checked when the 3rd minute has passed.
At this 3rd minute it needs to check if price <= 50% of previous candle body.

Can you tell me what block I will need for this?

Thank you

I just noticed that the issue described above in this topic still applies when using the adjust field with Variables instead of Constants. toDigits works VariableName pips doesn't. Any chance you can have a look at this?

Ok I found out why it didn't work for me, I had to place the blocks in 'On Charts' not 'On tick'.

So all is fine now;)

I tried again using the project Miro created, still nothing.... so I am not getting arrows. I see status showing: waiting for tick....

Probably a rookie mistake on my side , If you have an idea what I am missing please let me know.

Cheers.

Thanks a lot for your work. I tested both ways, but for some reason nothing seems to be happening, any idea what it could be?

Thanks for the response. I tried as far as I could understand but nothing seems to happen.

This is what I have come up with: https://fxdreema.com/shared/Y2xQHQg0e

Can you please point me in the right direction?

Hello,

Can you please point me in the direction for the following.

I want that the indicator spots only the first red or green closed bar above MA.

In this picture you see an example where the first red bar has closed above the MA:

Thank you in advance.

Thanks it seems to work now!

I can't get a something done that I think is likely very simple.

For example if a red candle forms draw arrow. I manage to get the Arrow but only on the current candle, I want that the indicator shows me all red candles with an arrow when loading the indicator (over a lookback period).

I used to use EAbuilder, which did this automatically. I am sure Fxdreema can do it.

Can you tell me how?

Thanks

Another question about this. I noticed a partial close will create new orders in mt4 so it will replace the existing variable (which is stored in memory). Is there a way to avoid this? I don't want that partial closes will use a new candle 1 to write to an existing variable. Hope it is clear.

Thanks will have a look at that.