Topics created by Setsuna

No, it's not correct. TVI can have one only value at a time and you are asking for that value to have two different numbers. That's impossible. However that can happen on different candles. Now both conditions are required for candle 0 so that will never happen.

That never happened to me. That's weird.

OCO order means "One cancels the other" .. You place 2 orders and if 1 of them gets executed the other one gets deleted. Some stock brokers offer that order type. For forex brokers I haven't seen it, yet.

Can you please share your project to find the problem?

I would also blame the history data. I'm not aware of anything in the code that can change the behavior of the Tester. Almost everything in the code happens in that OnTick() function that is automatically called by the Tester on each tick. So it's the Tester that is preparing the ticks data before even start testing, and then using that data to call OnTick().

Just in case, you can try another EA... even EA downloaded from internet. I think you should see the same effect on any EA. But if you see it only on FxDreema EAs, then this obviously means that the problem is in them and I need to investigate it.

For each trade is used to 'capture' info about all runninf trades right now. If you want to launch pending orders, it is not necessary. You'd better us the pending order block with the offset setting.

As far as I can tell, it's a broker's error. I've never experienced anything like that on eny fxDreema EA so far.

@ambrogio thx

Are you sure? It works fine in my MT4. That problem about pips can be fixed by adjusting the pip size rules.

@miro1360 for some reason my current project does not what i want. to buy or sell when the rate is 100 more or less then the opening price of the current candle I need to use "slide order"? I though price offset was the same with slide order

I think I am a little confuse whats the difference with slide order and price offset

beside it want i trade 1 time per hour. but sometime it trade 3 time on the same hour. and sometimes it doesnt trade

@spuzy thank you so much. I will try

can more explain?

@Setsuna hi did you find out it works? I want to be able to close only profitable buy trades only when rsi is above 70.
Also close only profitable sell trades when rsi is below 30

"Condition" block with

CandleClose[ID = 1] <= CandleMiddleValue [2]

As you said

Condition 2 -> ID 1 closing need to be at the middle or lower of ID 2

@fxdreema Thank you so much for the reaction

@josecortesllobat for some reason it doesnt work

The candle itself has high and low. If we take Moving Average for example, it can be applied to these prices:

0_1548372524269_c2b6ebd5-e74a-4f0f-8aa7-2f50c50dfeb6-image.png

By default the applied price is Close, which means that you get MA of only the Close prices of the candles. You can try to set MA to 1, change the applied price and you will get the idea.

If you are asking about something, I'm not sure what it is...

I have try to connect trailing stop block on the yellow connector on the time filter. But the result is stil negative.
0_1547988794937_8bee055a-9cf2-4035-88b5-2dbc3a82f536-image.png
this is the picture inside the block the connection is still the same as the picture above