Posts made by fxgjg

HOW can I count BULL or BEAR candles over a period of time?

Hi all,
I've checked through past topics but cannot find specifically a block or how to count past candles of BULL or Bear type that appeared over e.g. the MA 90 Line?

How can plot on the chart an MA line from a higher time frame.
For example while viewing the 5 minute chart, how can i draw a SMA line from the 15 minute time frame so i can see it on the 5 chart?
Thanks

This does not seem to work can you explain further?

How can plot on the chart an MA line from a higher time frame.
For example while viewing the 5 minute chart, how can i draw a SMA line from the 15 minute time frame so i can see it on the 5 chart?
Thanks

Hi

I have created red and blue horizontal lines on the chart but i cannot place my buy and sell trades above the blue line and below the sell line. Help please.
I have attached to link to my project below. Please let me know where i am going wrong?
Thanks

https://fxdreema.com/shared/SreTTeo6d

Thanks jstap. but this will not work as I need to has stricked an specific buy and sell points.
In your reply if multiple candles open and close but candle 1 never closes 10 pips in profit over candle 0 then no trades will be placed.
This will not work well

Hi
I have created red and blue horizontal lines on the chart but i cannot place my buy and sell trades above the blue line and below the sell line. Help please.
I have attached to link to my project below. Please let me know where i am going wrong?
Thanks

https://fxdreema.com/shared/SreTTeo6d

@l-andorrà ok... so i have already uploaded the Renko offline chart as a custom indicator...but in the condition settings i have no uption to identify the candle high/low, bullish or bearish.. To be honest i don't know how to set up the input and output parameters and the enumerations...

@l-andorrà thanks ALL...
i inly need to know if it is posible to identify with fxDreema, a bullish renko candle and a bearish renko candle.?

Thanks

@l-andorrà thanks, sorry for the late reply.
link below.

The condition i would like to set up is to be able to read the highs and lows of the Renko bricks and/or whether the brick is bulish or bearish on close
i have make a feeble attempt of setting up the enumerations and buffers... HELP

https://fxdreema.com/shared/qlOzawPpe

Hi there...
I've placed my renko chart (mt4), uploaded as costum indicator.
However, I cannot seem to get it to work in the condition block.. I.E. brick high/low, brick open/close etc.
Browsed through the forum but could not find a suitable answer..

Been going back through the threads but couldn't find if this is possible.
BTW i am using MT4.
I would like to close (take partial profit) when trade gets to 90% of stop loss and then close the remainder at 200% of stop loss?

@l-andorrà Many thanks

Hi all. Good morning.
How can i check when MA50 is above MA10 in candle 1...
Thanks

@fxgjg 'Check Loss' not profit..

Is there a way to check the loss of a trade without using the 'For each trade' 'check profit' blocks..

Thanks in advance

Yes...it was my error... thanks @l-andorrà

oohh... i have released that it was the spread that was the difference in price as i was closing out the wrong order.... thanks

I have used the Check Average Block and stated that i would like to close trades when the profit reaches $200 (money).
Most of the time on either Buy or SELL trades the profit goes to $224...
I would really love to only take $200 all the time not $224